Chapter 5 Maintaining Your Library
Monitoring the Library
Scalar i2000 User’s Guide 218
• Mail, save, or print status information by using the Send button
(see
Mailing, Saving, and Printing Status Information on
page 230).
Filtering Slots From the Status List 5
You can specify the slots that you want to appear in the status list by
selecting location, slot type, and state criteria from the Filter area of the
Slots Status dialog box.
1 Use one or more of the following drop-down lists to specify the slots
that you want to appear in the status list:
• To specify slots by location, click the appropriate option from
each of the Location drop-down lists: Aisle, Module, Rack,
Section, Column, and Row. The defaults are set to All unless a
drop-down list does not have more than one option. For
example, the Aisle drop-down list is always set to 1 by default
because only one aisle exists in the library. Therefore, the drop-
down list also is grayed out and selections cannot be made from
it.
These selections correspond to location coordinates for the physical
library. For example, to select all slots in the drive-side rack of the control
module, click 1 for module, 1 for rack, All for section, All for column, and
All for row. For more information about location coordinates, see
Understanding Location Coordinates on page 366.
• To specify slots by media type, click All or a specific media type,
such as LTO, from the Slot Type drop-down list. Only media
types that are currently used in the library appear in the drop-
down list. The default is set to All.
• To specify slots by slot state, click All, Occupied, or Empty from
the State drop-down list. The default is set to All.
2 Click Show.
To Next Page
Loading...
Need help?
General