Chapter 5 Maintaining Your Library
Maintenance Actions
Scalar i2000 User’s Guide 243
The following table describes the elements that appear in this area. For
descriptions of elements in the Fibre Channel Parameters and Control
areas, see
Configuring and Testing Drives on page 238.
Element Description
Drive Model The brand name of the drive model.
Vendor The drive vendor.
Firmware Level The firmware version that is currently installed on the drive.
Physical SN The serial number of the particular drive.
Logical SN The logical serial number that the library assigns to a drive in a specific
location. This is not the serial number of the particular drive (see Physical SN
in this table). If a drive is replaced by another drive in the same library
location, the logical serial number remains the same. From the host’s
perspective, the replacement drive is the same as the original one. If the logical
serial number addressing feature is disabled for the library, Disabled appears
in this field.
Location The location of the drive by means of a coordinate system. For information
about location coordinates, see the Scalar i2000 User’s Guide.
Media Type The type of drive (for example, LTO2 for LTO-2 tape drives).
Interface Type The type of interface (FC or SCSI).
WWN For Fibre drives only, the World Wide Name of the drive. This field does not
appear for SCSI drives.
SCSI ID For SCSI drives only, the SCSI ID of the drive. This field does not appear for
Fibre drives.
Assigned LUN The assigned logical unit number.
Volser If a cartridge is loaded in the specified drive, the volume serial number of the
cartridge.
Online Status The status of the drive (Varied On or Varied Off).
To Next Page
Loading...
Need help?
General