Chapter 5 Maintaining Your Library
Maintenance Actions
Scalar i2000 User’s Guide 336
For information about taking the library offline, see Changing the
Library’s State on page 380.
2 On the operator panel, press Robotics Enabled to turn off power to
the picker and return it to the home position.
The power is on to all other components.
3 Open the access door.
Aisle power is disabled.
4 Place the filter in the opening.
5 Place the retaining bar over the filter to hold it in place. Use the
Phillips screwdriver to tighten the two retaining thumbscrews.
6 Close the access door.
7 On the operator panel, press Robotics Enabled to enable the picker.
8 Bring the library online. See Changing the Library’s State on
page 380.
thumbscrew
retaining bar
thumbscrew
To Next Page
Loading...
Need help?
General