R&S ZVB - Page 829

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 814
[SENSe<Ch>:]CONVerter:AMODel <Boolean>
[Deprecated command, superseded by
SOURce<Ch>:POWer<Port>:CONVerter:TRANsfer:DESCription]
Enables or disables the RF In Power (and Electronic Attenuator) with Linear Approximation power control
method (SOURce<Ch>:POWer<Pt>:CONVerter:TRANsfer:DESCription LAPProx) on all
frequency converter ports.
Since FW version 3.40 this is a global setting.
<Ch>
Channel number. This suffix is ignored, the command affects all channels.
<Boolean>
ON | OFF - Enables or disables the advanced model
*RST value
n/a (a *RST does not affect the general frequency converter settings)
SCPI, Command
Types
Device-specific, command or query
Example:
CONV:AMOD ON; DESC LAPP
Enable the advanced power transfer model based on a linear approximation
for all converter ports.
[SENSe<Ch>:]CONVerter:ASSign<Port> '<Serial #>'
Assigns a R&S ZCxxx converter to port no. <Port> (see Port Assignment).
The adequate converter type and test setup have to be set beforehand using
[SENSe<Ch>:]FREQuency:CONVersion:DEVice:NAME and
[SENSe<Ch>:]FREQuency:CONVersion:DEVice:MODE, respectively.
This is a global setting.
<Ch>
Channel number. This suffix is ignored, the command affects all channels.
<Port>
NWA port number
'<Serial #>'
Serial number of the converter.
For converters of the R&S ZCxxx family this value should be set correctly.
For converters of the ZVA-Zxxx family it should be set to the empty string.
*RST value
n/a (a *RST does not affect the general frequency converter settings)
SCPI, Command
Types
Device-specific, command or query
Example:
CONV:ASS1 '100001'
[SENSe<Ch>:]CONVerter:DESCription DSET | LAPProx | ELECtronic | NONE
[Deprecated command, superseded by
SOURce<Ch>:POWer<Port>:CONVerter:TRANsfer:DESCription]
Selects the power control method for all converter ports. Overwrites the port specific setting of
SOURce<Ch>:POWer<Pt>:CONVerter:TRANsfer:DESCription.