RL78/G1H CHAPTER 5 PORT FUNCTIONS
R01UH0575EJ0120 Rev. 1.20 Page 77 of 920
Dec 22, 2016
Note 1. Control bits for internal pins. After reset release, be sure to set to output mode by software (set 0 to port
mode register).
Note 2. Control bits for internal connecting pins. After reset release, be sure to set to output mode by software (set 0
to port mode register).
Note 3. Control bits for internal connecting pins. After reset release, be sure to set to input mode by software (set 1 to
port mode register).
Caution Be sure to set bits that are not mounted to their initial values. For the register that has an instruction
to clear the bit to 0, clear it to 0.
To Next Page
Loading...
Need help?
General
