Rohde & Schwarz SMBV100A - Page 448

Instrument Function
R&S
®
SMBV100A
433Operating Manual 1176.8016.02 ─ 17
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier:COUNt on page 619
Carrier State
Switches the carriers in the range "Carrier Start" to "Carrier Stop" on/off.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STATe on page 630
Carrier Start
Defines the start index of the carrier range to which the assistant settings are intended
to apply.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STARt on page 629
Carrier Stop
Defines the stop index of the carrier range to which the assistant settings are intended
to apply.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STOP on page 629
Gain Start
Sets the gain of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer[:STARt]
on page 629
Gain Step
Sets the step width that is used to increment the gain
The resulting carrier gain in the carrier table equals:
GainStart + n* Gain Step
where n ranges from 0 to (Carrier Stop - Carrier Start).
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP
on page 628
Phase Start
Sets the phase of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe[:STARt]
on page 628
Phase Step
Sets the step width that is used to increment the phase.
The resulting phase in the carrier table equals:
PhaseStart + n* PhaseStep
where n ranges from 0 to (Carrier Stop – Carrier Start)
Baseband Signal - Baseband Block