Rohde & Schwarz SMBV100A - Page 696

Remote Control Commands
R&S
®
SMBV100A
681Operating Manual 1176.8016.02 ─ 17
Parameters:
<Points> integer
Range: 0 to INT_MAX
*RST: 0
Example:
BB:DM:DLIS:POIN 234
defines the number of bits in the data list to be utilized as 234
bits. If the list was filled with block data, at least the last 6 bits
will be ignored.
[:SOURce<hw>]:BB:DM:DLISt:SELect <Select>
The command selects the data list in the default directory. The default directory is set
using command MMEM:CDIRectory. A path can also be specified, in which case the
files in the specified directory are selected. If a data list with the specified name does
not yet exist, it is created. The file extension may be omitted. Only files with the file
extension *.dm_iqd will be selected or created.
The modulation data in this data list is used when the data source is selected using the
command SOURce:BB:DM:SOURce DLISt.
Parameters:
<Select> <list name>
Example:
BB:DM:DLIS:SEL 'd_list2'
selects data list d_list2.
Manual operation: See "Functions for handling of data lists" on page 166
[:SOURce<hw>]:BB:DM:FLISt:DELete <Filename>
Deletes the secified user filter file. The default directory is set using command
MMEM:CDIRectory. A path can also be specified, in which case the files in the speci-
fied directory are read. The file extension may be omitted. Only files with the file exten-
sion *.vaf*.vaf will be deleted.
Setting parameters:
<Filename> string
Example:
BB:DM:FILT:TYPE USER
selects the User filter type.
MMEM:CDIR '/var/user/Filter_List'
sets the default directory for the user-defined filters.
BB:DM:FLIS:DEL user_filter3
deletes the user-defined filter.
Usage: Setting only
Manual operation: See "Load User Filter" on page 361
SOURce Subsystem