Rohde & Schwarz SMBV100A - Page 773

Remote Control Commands
R&S
®
SMBV100A
758Operating Manual 1176.8016.02 ─ 17
Example
The following example shows how to set an LF sweep.
1. Set the sweep range.
LFOutput:FREQuency:STARt 4 kHz
LFOutput:FREQuency:STOP 10 kHz
2. Select linear or logarithmic sweep spacing.
LFOutput:SWEep[:FREQuency]:SPACing LIN
3. Set the step width and dwell time.
LFOutput:SWEep[:FREQuency]:STEP[:LINear] 100 Hz
LFOutput:SWEep[:FREQuency]:DWELl 20 ms
4. Determine the sweep mode.
LFOutput:SWEep:MODE AUTO
5. Determine the trigger.
TRIGger0:SOURce SINGle
6. Activate the sweep.
LFOutput:FREQuency:MODE SWEep
7. Trigger the sweep (depending on the mode).
LFOutput:SWEep:EXECute
[:SOURce]:LFOutput:FREQuency....................................................................................758
[:SOURce<hw>]:LFOutput:FREQuency:MANual............................................................... 759
[:SOURce<hw>]:LFOutput:FREQuency:MODE................................................................. 759
[:SOURce<hw>]:LFOutput:FREQuency:STARt................................................................. 760
[:SOURce<hw>]:LFOutput:FREQuency:STOP.................................................................. 760
[:SOURce]:LFOutput[:STATe]..........................................................................................761
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl................................................... 761
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute................................................ 761
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE....................................................762
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:POINts...................................................762
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace............................................... 763
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?..............................................764
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe...................................................764
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing................................................ 764
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear]........................................ 765
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic..................................766
[:SOURce]:LFOutput:SHAPe...........................................................................................766
[:SOURce]:LFOutput:SIMPedance...................................................................................767
[:SOURce]:LFOutput:VOLTage........................................................................................767
[:SOURce]:LFOutput:FREQuency <Frequency>
Sets the frequency of the LF signal in LFO:FREQ:MODE CW|FIXed mode.
SOURce Subsystem