Sel 751A - Changing the Time; TIM (Time Command); Viewing the Time

1.19
Date Code 20100129 Instruction Manual SEL-751A Relay
Introduction and Specifications
Getting Started
TIM (Time Command)
Viewing the Time
Enter TIM at the prompt to view the time stored in the SEL-751A. The relay
will reply with the stored time. For example
13:52:44
This time is 1:52 p.m. (and 44 seconds).
Changing the Time
Enter TIM followed by the correct time at the action prompt to change the
time stored in the relay. For example, to change the time to 6:32 a.m., enter the
following at the prompt:
TIM 6:32:00
You can separate the hours, minutes, and seconds parameters with spaces,
commas, slashes, colons, and semicolons.