EasyManua.ls Logo

Siemens 7SJ85 - Settings; Information List

Siemens 7SJ85
1638 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parameter: Down integration time
Default setting (_:13861:102) Down integration time = 3.00 min
Use the parameter Down integration time in order to determine the duration until the internal integra-
tion value is linearly reduced from 100 % to 0 %.
For example, if the integration value is 52 %, a duration of 52 % × down integration time is required until the
integration value 0 % is reached. When using this parameter, the preloading of a capacitor can be considered
and therefore released quicker.
If you are knowledgeable about recovery time of stressed capacitors, they can be considered with this param-
eter.
Parameter: Dropout delay
Default setting (_:13861:7) Dropout delay = 1.00 s
The parameter Dropout delay can be used to prevent resetting of the integral value in the event that the
measured value briefly falls below the dropout threshold.
Settings
Addr. Parameter C Setting Options Default Setting
General
_:2311:101 General:Capacitor rated
current
1.0 A to 100000.0 A 1000.0 A
Inverse-T 1
_:13861:1 Inverse-T 1:Mode
off
on
test
off
_:13861:2 Inverse-T 1:Operate &
flt.rec. blocked
no
yes
no
_:13861:103 Inverse-T 1:Dropout prin-
ciple
with dropout delay
with down integration
with down inte-
gration
_:13861:3 Inverse-T 1:Threshold 0.80 p.u. to 3.00 p.u. 1.10 p.u.
_:13861:102 Inverse-T 1:Down inte-
gration time
1 min to 1500 min 3 min
_:13861:7 Inverse-T 1:Dropout
delay
0.00 s to 3600.00 s 1.00 s
Information List
No.
Information Data Class
(Type)
Type
General
_:2311:301 General:VpeakA MV O
_:2311:302 General:VpeakB MV O
_:2311:303 General:VpeakC MV O
Group indicat.
_:4501:55 Group indicat.:Pickup ACD O
_:4501:57 Group indicat.:Operate ACT O
Inverse-T 1
_:13861:81 Inverse-T 1:>Block stage SPS I
_:13861:54 Inverse-T 1:Inactive SPS O
_:13861:52 Inverse-T 1:Behavior ENS O
_:13861:53 Inverse-T 1:Health ENS O
7.6.3.3
7.6.3.4
Capacitor Bank Protection
7.6 Peak Overvoltage Protection for Capacitors
SIPROTEC 5, Overcurrent Protection, Manual 1025
C53000-G5040-C017-8, Edition 07.2017

Table of Contents

Related product manuals