Siemens 7SJ85 - Settings; Information List

Settings
Addr. Parameter C Setting Options Default Setting
V-release #
_:1 V-release #:Mode
•
off
•
on
•
test
off
_:2 V-release #:Operate &
flt.rec. blocked
•
no
•
yes
no
_:10 V-release #:Blk. by
meas.-volt. failure
•
no
•
yes
yes
_:27 V-release #:Blk. w. inrush
curr. detect.
•
no
•
yes
no
_:8 V-release #:Method of
measurement
•
fundamental comp.
•
RMS value
fundamental
comp.
_:3 V-release #:Threshold 1 A @ 100 Irated 0.030 A to 35.000 A 1.500 A
5 A @ 100 Irated 0.15 A to 175.00 A 7.50 A
1 A @ 50 Irated 0.030 A to 35.000 A 1.500 A
5 A @ 50 Irated 0.15 A to 175.00 A 7.50 A
1 A @ 1.6 Irated 0.001 A to 1.600 A 1.500 A
5 A @ 1.6 Irated 0.005 A to 8.000 A 7.500 A
_:101 V-release #:Type of char-
acter. curve
•
ANSI long-time inv.
•
ANSI short-time inv.
•
ANSI extremely inv.
•
ANSI very inverse
•
ANSI normal inverse
•
ANSI moderately inv.
•
ANSI definite inverse
•
IEC normal inverse
•
IEC very inverse
•
IEC extremely inv.
•
IEC long-time inverse
IEC normal
inverse
_:102 V-release #:Reset
•
instantaneous
•
disk emulation
disk emulation
_:103 V-release #:Time dial 0.05 to 15.00 1.00
_:104 V-release #:Under-
voltage threshold
0.300 V to 175.000 V 75.000 V
Information List
No.
Information Data Class
(Type)
Type
V-release #
_:81 V-release #:>Block stage SPS I
_:500 V-release #:>Block delay & op. SPS I
_:54 V-release #:Inactive SPS O
_:52 V-release #:Behavior ENS O
_:53 V-release #:Health ENS O
_:60 V-release #:Inrush blocks operate ACT O
_:59 V-release #:Disk emulation running SPS O
_:55 V-release #:Pickup ACD O
_:56 V-release #:Operate delay expired ACT O
_:57 V-release #:Operate ACT O
6.4.4.3
6.4.4.4
Protection and Automation Functions
6.4 Voltage-Dependent Overcurrent Protection, Phases
368 SIPROTEC 5, Overcurrent Protection, Manual
C53000-G5040-C017-8, Edition 07.2017