Structure of the Function
Depending on the interconnection of the function groups, these can contain different measured-value groups.
A typical function group is displayed below.
Voltage/Current 3-Phase Function Group Type
In the simplest version the Voltage/Current 3-phase function group obtains the measured values of the 3-
phase voltage and current system and contains the following measured-value groups:
[dwstrciv-011012-01.tif, 1, en_US]
The Minimum values/Maximum values/Average values and User-defined values can be inserted from the
library into the Voltage/Current 3-phase function group.
Details regarding the individual measured value groups can be found in the tables in the following chapters.
Circuit-Breaker Function Group
The Circuit-breaker function group may contain the following measured values:
10.2
Measured Values, Energy Values, and Supervision of the Primary System
10.2 Structure of the Function
SIPROTEC 5, Overcurrent Protection, Manual 1309
C53000-G5040-C017-8, Edition 07.2017
To Next Page
Loading...
