[dwbreake-220512-01.tif, 1, en_US]
Figure 8-4
Control Function Blocks of the Circuit-Breaker Switching Device
The circuit breaker in DIGSI 5 is linked with the binary inputs that acquire the switch position via information
routing. The circuit breaker in DIGSI 5 is also linked with the binary outputs that issue the switching
commands.
NOTE
When setting the parameters of a device, you will find 2 circuit-breaker types in the DIGSI 5 library:
- 3-pole circuit breaker or 1-pole circuit breaker, depending on the device type selected (3-pole or 1-pole
tripping)
- Circuit breaker (status only)
Control Functions
8.2 Switching Devices
1078 SIPROTEC 5, Overcurrent Protection, Manual
C53000-G5040-C017-8, Edition 07.2017
To Next Page
Loading...
