[scfgcols-220211-01.tif, 1, en_US]
Figure 2-5 Connection of Protection Function Group with Circuit-Breaker Function Group
Besides the general assignment of the protection function group(s) to the circuit-breaker function groups, you
can also configure the interface for specific functionalities in detail. Proceed as follows:
•
Open the SIPROTEC 5 device folder in the DIGSI 5 project tree.
•
Open the function settings folder in the DIGSI 5 project tree.
•
Open the respective protection function group in the DIGSI 5 project tree, for example, Line 1 (see the
following figure)
Basic Structure of the Function
2.1 Function Embedding in the Device
48 SIPROTEC 5, Overcurrent Protection, Manual
C53000-G5040-C017-8, Edition 07.2017
To Next Page
Loading...
