Siemens SCALANCE W1750D UI

Wired Profiles
12.1 Configuring a Wired Profile
SCALANCE W1750D UI
152 Configuration Manual, 02/2018, C79000-G8976-C451-02
3.
Accounting
—Select any of the following options:
–
Disabled
—Disables accounting.
–
Use authentication servers
—When selected, the authentication servers configured for
the wired profile are used for accounting purposes.
–
Use separate servers
—Allows you to configure separate accounting servers.
–
Accounting interval
—Allows you set an accounting interval within the range of 0–60
minutes for sending interim accounting information to the RADIUS server.
–
Reauth interval
—Specify the interval at which all associated and authenticated clients
must be reauthenticated.
4.
Load balancing
—Set this to
Enabled
if you are using two RADIUS authentication servers,
so that the load across the two RADIUS servers is balanced. For more information on the
dynamic load balancing mechanism, see Dynamic Load Balancing between Two
Authentication Servers on page 154.
5. Click
Next
. The
Access
tab details are displayed
In the CLI
To configure security settings for an employee network:
(scalance)(config)# wired-port-profile <name>
(scalance)(wired ap profile <name>)# mac-authentication
(scalance)(wired ap profile <name>)# l2-auth-failthrough
(scalance)(wired ap profile <name>)# auth-server <name>
(scalance)(wired ap profile <name>)# server-load-balancing
(scalance)(wired ap profile <name>)# radius-accounting
(scalance)(wired ap profile <name>)# radius-accounting-mode {user-association|user-
authentication}
(scalance)(wired ap profile <name>)# radius-interim-accounting-interval <minutes>
(scalance)(wired ap profile <name>)# radius-reauth-interval <Minutes>
(scalance)(wired ap profile <name>)# trusted (scalance)(wired ap profile <name>)# end
(scalance)# commit apply