Siemens SCALANCE W1750D UI

Deep Packet Inspection and Application Visibility
22.5 Configuring ACL Rules for Application and Application Categories
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
367
22.5
Configuring ACL Rules for Application and Application Categories
This section describes the procedure for configuring access rules based on application and
application categories. The Application and Application rules utilize the onboard DPI engine.
● For information on configuring access rules to control access to network services, see
Configuring ACL Rules for Network Services (Page 244).
● For information on configuring access rules based on web categories and web reputation,
see Configuring Web Policy Enforcement Service (Page 371).
In the SCALANCE W UI
To configure ACL rules for a user role:
1. Navigate to the
Security > Roles
tab. The
Roles
tab contents are displayed. You can also
configure access rules for a wired or wireless client by using:
– The WLAN wizard (
Network > WLAN SSID > Edit > Edit WLAN > Access
) or
– The Wired profile (
More > Wired > Edit > Edit Wired Network > Access
) window.
2. Select the role for which you want to configure the access rules.
3. In the
Access rules
section, click
New
to add a new rule. The
New Rule
window is
displayed.
4. Ensure that the rule type is set to
Access Control
.
5. To configure access to applications or application category, select a service category
from the following list:
– Application
– Application category