Hotspot Profiles
33.2 Configuring Hotspot Profiles
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
511
pame-bi Specify this parameter to enable Pre-Association Message Exchange
BSSID Independent (PAME-BI) bit, with which the AP can indicate that the
Advertisement Server can return a query response independent of the
BSSID used in the GAS Frame exchange.
query-response- length-
limit
Specify this parameter to set the maximum length of the GAS query re-
sponse, in octets. You can specify a value within the range of 1–127. The
roam-cons-len-1 roam-
cons-len-2 roam-cons-
len-3
Specify the length of the organization identifier (OI). That is, the value for
the length of OIs of
,
, or
.
The roaming consortium OI is based on the following parameters:
•
: Zero Octets in the OI (Null)
•
: OI length is 24-bits (3 Octets)
•
: OI length is 36-bits (5 Octets)
venue-group Specify one of the following venue groups
• unspecified
• assembly
• business
• educational
• factory-and-industrial
• institutional l mercantile l outdoor
• residential
• storage
• utility-misc
• vehicular
By default, the business venue group is used.
venue-type Specify a venue type to be advertised in the ANQP IEs from APs associat-
ed with this hotspot profile. For more information about the supported
venue types for each venue group, see Table Venue Types.
Associating an Advertisement Profile to a Hotspot Profile
To associate a hotspot profile with an advertisement profile:
(scalance)(config)# hotspot hs-profile <name>
(scalance)(Hotspot2.0 <name>)# advertisement-protocol <protocol>
(scalance)(Hotspot2.0 <name>)# advertisement-profile anqp-3gpp <name>
(scalance)(Hotspot2.0 <name>)# advertisement-profile anqp-domain-name <name>
(scalance)(Hotspot2.0 <name>)# advertisement-profile anqp-ip-addr-avail <name>
(scalance)(Hotspot2.0 <name>)# advertisement-profile anqp-nai-realm <name>
(scalance)(Hotspot2.0 <name>)# advertisement-profile anqp-nwk-auth <name>
(scalance)(Hotspot2.0 <name>)# advertisement-profile anqp-roam-cons <name>
(scalance)(Hotspot2.0 <name>)# advertisement-profile anqp-venue-name <name>