Siemens SCALANCE W1750D UI User Manual

VPN Configuration
19.3 Configuring Routing Profiles
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
323
19.3
Configuring Routing Profiles
APs can terminate a single VPN connection on an Mobility Controller. The routing profile
defines the corporate subnets which need to be tunneled through IPsec. You can configure
routing profiles for policy based routing into the VPN tunnel using the SCALANCE W UI or
the CLI.
In the SCALANCE W UI
To configure a routing profile:
1. Click
Routing
in the
Tunneling
window. The routing details are displayed.
2. Click
New
. The route parameters to configure are displayed.
Figure 19-7 Tunneling— Routing
3. Update the following parameters:
–
Destination
— Specify the destination network that is reachable through the VPN
tunnel. This defines the IP or subnet that must reach through the IPsec tunnel. Traffic
to the IP or subnet defined here will be forwarded through the IPsec tunnel.
–
Netmask
—Specify the subnet mask to the destination.
–
Gateway
—Specify the gateway to which the traffic must be routed. This IP address
must be the controller IP address on which the VPN connection is terminated. If you
have a primary and backup host, configure two routes with the same destination and

Siemens SCALANCE W1750D UI Specifications

General

Brand	Siemens
Model	SCALANCE W1750D UI
Category	Wireless Access Point
Language	English