SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
147
Configuring a Wired Profile
The Ethernet ports allow third-party devices such as VoIP phones or printers (which support
only wired connections) to connect to the wireless network. You can also configure an
Access Control List (ACL) for additional security on the Ethernet downlink.
The wired profile configuration for Employee network involves the following procedures:
1. Configuring Wired Settings (Page 147)
2. Configuring VLAN for a Wired Profile (Page 149)
3. Configuring Security Settings for a Wired Profile (Page 151)
4. Configuring Access Rules for a Wired Profile (Page 153)
For information on creating a wired profile for guest network, see Captive Portal for Guest
Access (Page 161).
Configuring Wired Settings
You can configure wired settings for a wired profile by using the SCALANCE W UI or the
CLI.
1. Click the
link under
on the SCALANCE W main window. The
window
is displayed.
2. Click
under
. The
window is displayed.
3. Click the
tab and configure the following parameters:
–
—Specify a name for the profile.
–
—Select
or
.
–
—Ensure that appropriate values are selected for
.
Contact your network administrator if you need to assign speed and duplex
parameters.
–
—Set
to
to enable Power over Ethernet.
–
—Ensure that an appropriate value is selected. The
indicates if the port is up or down.
4. Click
and configure the following parameters as required:
–
—To ensure that all DNS requests to non-corporate domains on this
wired network are sent to OpenDNS, select
for
.
–
—Select
to configure uplink on this wired profile. If
is set to
and this network profile is assigned to a specific port, the port will be enabled
To Next Page
Loading...
