Siemens SCALANCE W1750D UI

ClearPass Guest Setup
34.2 Verifying ClearPass Guest Setup
SCALANCE W1750D UI
526 Configuration Manual, 02/2018, C79000-G8976-C451-02
34.2
Verifying ClearPass Guest Setup
To verify the setup:
1. Disconnect your AppleTV and OSX Mountain Lion/iOS 6 devices if they were previously
connected to the wireless network. Remove their entries from the controller’s user table
using these commands:
–
Find the MAC address—
show user table
– Delete the address from the table—
aaa user delete mac 00:aa:22:bb:33:cc
2. Reconnect both devices. To limit access to the AppleTV, access the ClearPass Guest UI
using either the AirGroup admin or the AirGroup operator credentials. Next, navigate to
List Devices > Test Apple TV > Edit
. Add a username that is not used to log in to the
Apple devices in the
Shared With
box.
3. Disconnect and remove the OSX Mountain Lion/iOS 6 device from the controller’s user
table. Reconnect the device by not using the username that you added to the
Shared
With
box. The AppleTV should not be available to this device.
4. Disconnect the OSX Mountain Lion/iOS 6 device and delete it from the controller’s user
table. Reconnect using the username that was added to the
Shared With
box. The OSX
Mountain Lion/iOS 6 device should once again have access to the AppleTV.