Siemens SCALANCE W1750D UI User Manual

Customizing AP Settings
8.6 Changing USB Port Status
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
95
8.6
Changing USB Port Status
he USB port can be enabled or disabled based on your uplink preferences. If you do not
want to use the cellular uplink or 3G/4G modem in your current network setup, you can set
the USB port status to disabled. By default, the USB port status is enabled.
You can change the USB port status by using the SCALANCE W UI or the CLI.
In the SCALANCE W UI
To change the USB port status
1. From the Access Points tab, click the AP to modify.
2. Click the
edit
link.
3. Click the
Uplink
tab.
4. Set the port status by selecting any of the following options:
–
Disabled
—To disable the port status.
–
Enabled
—To re-enable the port status.
5. Click
OK
.
6.
7. Reboot the AP.
In the CLI
To disable the USB port:
(scalance)# usb-port-disable
To re-enable the USB port:
(scalance)# no usb-port-disable
To view the USB port status:
(scalance)# show ap-env Antenna Type:External
usb-port-disable:1

Siemens SCALANCE W1750D UI Specifications

General

Brand	Siemens
Model	SCALANCE W1750D UI
Category	Wireless Access Point
Language	English