Siemens SCALANCE W1750D UI

Customizing AP Settings
8.8 Adding an AP to the Network
SCALANCE W1750D UI
98 Configuration Manual, 02/2018, C79000-G8976-C451-02
8.8
Adding an AP to the Network
To add an AP to the SCALANCE W network, assign an IP address. For more information,
see Assigning an IP address to the AP (Page 30).
After an AP is connected to the network, if the Auto-Join feature is enabled, the AP inherits
the configuration from the VC and is listed in the
Access Points
tab.
If the auto-join mode is disabled, perform the following steps by using the SCALANCE W UI.
In the SCALANCE W UI:
To add an AP to the network:
1. On the
Access Points
tab, click the
New
link.
2. In the
New Access Point
window, enter the MAC address for the new AP.
3. Click
OK
.