Siemens SCALANCE W1750D UI

Deep Packet Inspection and Application Visibility
22.6 Configuring Web Policy Enforcement Service
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
371
22.6
Configuring Web Policy Enforcement Service
You can configure the WPE service on an AP to block certain categories of websites based
on your organization specifications by defining ACL rules by using the SCALANCE W UI or
the CLI.
In the SCALANCE W UI
To configure WPE service:
1. Navigate to
Security > Roles
.
2. Select any WLAN SSID or wired profile role, and click
New
in the Access Rules section.
3. Select the rule type as
Access Control
.
4. To set an access policy based on the web category:
–
Under
Service
, select
Web category
and expand the
Web categories
drop-down list.
Figure 22-14 Web Policy Enforcement
– Select the categories to which you want to deny or allow access. You can also search
for a web category and select the required option.
–
From the
Action
drop-down list, select
Allow
or
Deny
as required.
– Click
OK