Siemens SCALANCE W1750D UI

Hotspot Profiles
33.2 Configuring Hotspot Profiles
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
501
(scalance)(nai-realm <name>)# nai-realm-auth-id-2 <authentication-ID>
(scalance)(nai-realm <name>)# nai-realm-auth-value-1 <authentication-value>
(scalance)(nai-realm <name>)# nai-realm-auth-value-2 <authentication-value>
(scalance)(nai-realm <name>)# nai-home-realm
(scalance)(nai-realm <name>)# enable
(scalance)(nai-realm <name>)# end
(scalance)# commit apply
You can specify any of the following EAP methods for the
nai-realm-eap-method <eap-
method>
command:
●
identity
- To use EAP Identity type. The associated numeric value is 1.
●
notification
- To allow the hotspot realm to use EAP Notification messages for
authentication.
The associated numeric value is 2.
●
one-time-password
- To use Authentication with a single-use password. The associated
numeric value is 5.
●
generic-token-card
- To use EAP Generic Token Card (EAP-GTC). The associated
numeric value is 6.
●
eap-tls
- To use EAP-Transport Layer Security. The associated numeric value is 13.
●
eap-sim
- To use EAP for GlobaSystem for Mobile Communication (GSM) Subscriber
Identity Modules (SIM).
The associated numeric value is 18.
●
eap-ttls
- To use EAP-Tunneled Transport Layer Security. The associated numeric value
is 21.
●
peap
- To use protected Extensible Authentication Protocol. The associated numeric
value is 25.
●
crypto-card
- To use crypto card authentication. The associated numeric value is 28.
●
peapmschapv2
- To use PEAP with Microsoft Challenge Handshake Authentication
Protocoversion 2 (MSCHAPv2).
The associated numeric value is 29.
●
eap-aka
- To use EAP for UniversaMobile Telecommunications System (UMTS)
Authentication and Key Agreement (AKA).
The associated numeric value is 50.