Sirona Sinius - Page 185

63 22 726 D3561
D3561.201.01.03.02 05.2012
185
Sirona Dental Systems GmbH 5 Care, cleaning and maintenance by the practice team
Operating Instructions SINIUS / SINIUS CS 5.3 Instruments and instrument hoses
båÖäáëÜ
 Place all water-carrying instruments and suction hoses into the
receptacles.
5. Touch the
Start key on the touchscreen.
 First the treatment center checks whether there is water flow
through the instruments. This takes several minutes.
Error message: No water flow
If the treatment center detects no water flow through an instrument, you
can try to restore water flow through the relevant instrument. If this is not
possible, the instrument concerned can be excluded from the purging
process.
1. Check the water flow through the instruments in the instrument
positions marked with a warning triangle on the touchscreen. Set to
maximum water flow on the instruments. Leave all instruments
plugged into the water unit.
 If the treatment center detects the water flow, the warning triangle
will disappear. If water flow is detected for all instruments, the
autopurge program automatically continues.
2. If you want to exclude the instruments concerned from purging, touch
the
Exclude instrument key.
 The autopurge program continues. The water lines you excluded
are not included in the purging process.
Purge water paths
The removed instruments are purged with water for the duration of the set
purge time. Purging of the tumbler filler and cleaning of the suction hoses
then takes place. The progress bar displayed on the touchscreen refers
to the entire autopurge program, and not to the set instrument purge time.
IMPORTANT
Pinching of the instrument hoses
Be careful not to pinch the instrument hoses when inserting the
instruments.
If the hoses are pinched, the water flow will be obstructed during
purging.