17Table of Contents
Volume 3
Chapter 18 System Setup (System)
Setup for the Whole System.......................................................................834
Network Settings (Network Config Menu)...............................................835
Making the Network Settings..............................................................835
System Settings (System Config Menu)....................................................836
Selecting the System Operation Mode ................................................836
Specifying the Switcher Controlled by the Control Panel ..................837
Specifying the DME Connected to the Switcher.................................838
Setting the Signal Format (Format Menu)...............................................839
Setting the Signal Format ....................................................................839
Setting the Screen Aspect Ratio (Format Menu).....................................841
Selecting the State After Powering On (Start Up Menu)........................842
Saving and Recalling Setup Data ........................................................843
Selecting the State at Start-up .............................................................844
Saving User-Defined Settings .............................................................845
Setting Automatic Loading of Register Data at Power On (Autoload
Function) ..................................................................................845
Reset and Initialization (Initialize Menu).................................................847
Installation and Device Setup (Install/Unit Config Menu) .....................848
Installing Software ..............................................................................848
Making Settings Required to Use the Software ..................................850
Adding User Texture Patterns .............................................................853
Switching the Color Correction Function ...........................................860
System Maintenance (Maintenance Menu)..............................................861
Setting the Date and Time ...................................................................861
Using a Memory Card .........................................................................862
Carrying Out the Primary Setting........................................................862
Reloading a USB Driver......................................................................863
Initializing the Hard Disk....................................................................863
Locking the Setup Menu Settings .......................................................864
Chapter 19 Control Panel Setup (Panel)
Overall Control Panel Settings (Config Menu)........................................872
Panel Setup ..........................................................................................872
Interchanging the Bank Order or Disabling Operation .......................873
Assigning Two M/E Banks to One M/E Bank....................................874