347Color Corrector Functions
Chapter 9 Color Corrector
Secondary Color Correction Operations
For the six colors R (red), G (green), B (blue), Y (yellow), C (cyan), and M
(magenta), adjust the luminance and saturation, and also the hue within a range
of ±30 degrees of the center value for each color.
You can mask a part of the region to be corrected.
Note
When spot color adjustment is enabled in the setup settings, this function is
disabled.
For details, see “Switching the Color Correction Function” in Chapter 18
(Volume 3).
Applying secondary color correction
1
In the CCR menu, select VF1 ‘CCR1’ and HF3 ‘Secondary CCR.’
The Secondary CCR menu appears.
2
In the <Secondary CCR> group, press [Secondary CCR], turning it on.
3
In the <Secondary CCR Adjust> group, select the color for which you
want to make the setting.
4
Adjust the following parameters.
To return the parameter settings to their default values
In the <Secondary CCR> group press [Unity].
Masking a part of the secondary color correction
In the <Secondary Mask> group, press [Mask1] or [Mask2], turning it on, then
carry out the same operation as described under “Masking a part of the primary
color correction” (page 344).
Knob Parameter Adjustment Setting values
1 Luminance Luminance –100.00 to +100.00
2 Saturation Saturation 0.00 to 200.00
3 Hue Delay Hue delay –180.00 to +180.00
To Next Page
Loading...
