883Overall Control Panel Settings (Config Menu)
Chapter 19 Control Panel Setup (Panel)
The button you pressed appears in reverse video.
5
Using any of the following methods, select the transition type to be
assigned, from the list on the right.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
6
Press [Set].
The texts on the button illustrations change to reflect the selection.
To cancel the assignment
Press [Clear].
To make the assignment the default
Press [Default].
Setting VTR Operation Button Assignment
You can change the assignment of some of the buttons in the transition control
block for use in VTR operations.
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Transition Module].
The Transition Module menu appears.
3
Select the bank of the transition control block you want to set in the <Bank
Select> group.
In the center on the left, [NORM], [NORM/REV], and [REV] appear with
their current assignments.
On the lower left, [PTN LIMIT], [LIMIT SET], and [KF] appear with their
current assignments.
4
Press any of the [NORM], [NORM/REV], and [REV] buttons.
Knob Parameter Adjustment Setting values
1 Button
Assign
Selection of transition type 1 to 10
To Next Page
Loading...
