295Frame Memory Clip Operations
Chapter 7 Frame Memory
Frame Memory Clip Operations
For an overview of frame memory clip concepts, see “Frame Memory Clip
Function” (page 294).
Note
During playback of a frame memory clip of the pair assigned to either of the
target FM selection buttons (see page 297), frame memory operations may not
be performed properly. Carry out frame memory operations after stopping clip
playback.
Preparations for Operation
The preparations for using a frame memory clip (hereafter, a “clip”) are the
same as for a still image operation. See “Preparations” (page 271) and
“Selecting Outputs and Target Frame Memory” (page 276).
Recalling Clips
Recalling a clip
You can recall a clip from each of frame memories 1 to 8.
1
In the Frame Memory menu, select VF2 ‘Clip’ and HF1 ‘Recall.’
The Recall menu appears. (See following figure)
• When [Pair] is set to On, only pair files (sets of main file and sub file)
are shown.
• When [Pair] is set to Off, both of single files and pair files are shown.
To Next Page
Loading...
