772
Macro Timeline
Chapter 16 Macros
• On a macro timeline, only macro recall and execution actions are stored. The
data for a macro to be recalled on the macro timeline is not held on the
timeline. It is necessary to create the macro data first.
• A macro timeline can be saved and recalled on the master timeline or a
shotbox register, but cannot be saved as a snapshot.
Creating and Editing a Macro Timeline
This section describes how to set actions, and add keyframe points. Note that
path settings are not needed on the macro timeline.
For details of keyframe operations, see “Creating and Editing Keyframes”
(page 646).
Saving a keyframe
For the operations, use the Macro Timeline menu and the [INS] button in the
keyframe control block.
1
Press the [EDIT ENBL] button, turning it on.
This enables timeline editing in the keyframe control block.
2
In the Macro menu, select VF4 ‘Timeline’ and HF1 ‘Timeline.’
The Macro Timeline menu appears.
3
Select “Recall-1” that appears on the right.
As required, turn the knob to select the number of the macro register.
4
Press the [Set] button.
“Recall-1” appears in the Action column on the left.
5
Press the [INS] button in the keyframe control block.
This creates the keyframe “Recall-1” on the macro timeline.
To set the action for a rewind operation
On the macro timeline, when the [REWIND] button in the keyframe control
block is pressed the action set for the first keyframe is not executed; when the
[RUN] button is pressed, then the first keyframe action is executed.
Knob Parameter Adjustment Setting values
3 Recall No Selection of macro register 1 to 99
To Next Page
Loading...
