Sony DVS-9000 System - Selecting the Mode for Turning off Keys Upon Receiving the Editor Command

977Interfacing With External Devices (Device Interface Menu)
Chapter 20 Switcher Setup (Switcher)
Notes
• When using the MVE-8000A, it is not possible to select any of DME 1
Ext In to DME 8 Ext In.
• When using the BKDS-9470, it is not possible to select DME 1 to DME
8 (video/key).
4 In the <Select> group, select the AUX bus or reentry to be assigned to the
DME channel.
Aux Bus: Set AUX bus.
Re-Entry: Set reentry.
5 Depending on the selection in step 4, use any of the following methods to
make the setting.
• Press directly on the list on the right of the status area.
• Press directly on the list on the right of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
• When Aux Bus is selected
• When Re-Entry is selected
6 Press [Set].
In the list on the right of the status area, the selected content is reflected in
the specified DME channel.
Repeat steps 3 to 6 as required.
Selecting the Mode for Turning Off Keys Upon
Receiving the Editor Command
Selects the mode for turning off keys when an “All Stop” command is received
from the editor.
1 In the Switcher >Device Interface menu, press [Editor I/F].
The Editor I/F menu appears.
Knob Parameter Adjustment Setting values
2 Src No AUX bus number 0 to 48
Knob Parameter Adjustment Setting values
2 Src No Reentry number 0 to 80