Chapter 18 System Setup (System)
Setup for the Whole System .....................................................................834
Network Settings (Network Config Menu) .............................................835
Making the Network Settings ............................................................835
System Settings (System Config Menu) ..................................................836
Selecting the System Operation Mode ..............................................836
Specifying the Switcher Controlled by the Control Panel ................837
Specifying the DME Connected to the Switcher ...............................838
Setting the Signal Format (Format Menu) .............................................839
Setting the Signal Format ..................................................................839
Setting the Screen Aspect Ratio (Format Menu) ...................................841
Selecting the State After Powering On (Start Up Menu) ......................842
Saving and Recalling Setup Data ......................................................843
Selecting the State at Start-up ...........................................................844
Saving User-Defined Settings ...........................................................845
Setting Automatic Loading of Register Data at Power On (Autoload
Function) ................................................................................845
Reset and Initialization (Initialize Menu) ...............................................847
Installation and Device Setup (Install/Unit Config Menu) ...................848
Installing Software ............................................................................848
Making Settings Required to Use the Software ................................850
Adding User Texture Patterns ...........................................................853
Switching the Color Correction Function .........................................860
System Maintenance (Maintenance Menu) ............................................861
Setting the Date and Time .................................................................861
Using a Memory Card .......................................................................862
Carrying Out the Primary Setting ......................................................862
Reloading a USB Driver ....................................................................863
Initializing the Hard Disk ..................................................................863
Locking the Setup Menu Settings .....................................................864
To Next Page