Sony DVS-9000 System - Setting the Assignment of Macro Operation Buttons; Fade-To-Black Control Block

885Overall Control Panel Settings (Config Menu)
Chapter 19 Control Panel Setup (Panel)
To make the assignment the default
Press [Default].
Setting the Assignment of Macro Operation Buttons
Note
This setting is disabled for the CCP-9000/9000A.
To switch the [UNDO] button on a simple type Flexi Pad control block to a
[MCRO] button for macro operation, use the following procedure.
1 In the Panel >Config >Link/Program Button menu, press [Flexi Pad
Module].
The Flexi Pad Module menu appears.
2 Select the assignment of the [UNDO] button in the simple type Flexi Pad
control block from the <UNDO Button Assign> group.
UNDO: use as an [UNDO] button.
MACRO: use as a [MCRO] button.
Assigning Keys to the DSK1 and DSK2 Buttons in the
Downstream Key/Fade-to-Black Control Block
It is possible to select the key used for downstream key/fade-to-black control
block operations.
Note
This operation cannot be done in the CCP-9000/9000A.
1 In the Panel >Config >Link/Program Button menu, press [DSK/FTB
Module].
The DSK/FTB Module menu appears.
The left side of the status area shows the DSK1 and DSK2 buttons, and the
right side shows a list of keys to be assigned.
2 Press the indication (DSK1, DSK2) of the button for the assignment.
The button you pressed changes to reverse video.