322
Copy and Swap Operations
Chapter 8 Color Backgrounds, Copy and Swap, and Other Settings
Copy and Swap Operations
Copy and Swap Menu Operations
Accessing the Copy/Swap menu
In the menu operation section top menu selection buttons, press the [Copy/
Swap] button, then press VF1 ‘Copy/Swap.’ The Copy/Swap menu appears.
Here a copy/swap operation on wipe data is described by way of example,
using the Copy/Swap >Wipe menu, but the same general procedure applies to
all of the following menus.
• M/E: Copying and swapping M/E data
• Key: Copying and swapping key data
• Wipe: Copying and swapping wipe data
• DME Wipe: Copying and swapping DME wipe data
• Matte: Copying and swapping matte data
• Color: Copying and swapping color data
• DME: Copying and swapping data by DME channels
For an overview of the concepts involved, see “Copy and Swap” (page 318).
For details of color corrector copy and swap, see Chapter 9 “Color
Corrector” (page 337).
Note
To use DME requires the BKDS-9470 DME Board Set or the MVE-8000A/
9000 Multi Format DME Processor.
Copying and swapping wipe data
As an example, to copy or swap wipe data, use the following procedure.
1
In the Copy/Swap menu, select HF3 ‘Wipe.’
The Copy/Swap >Wipe menu appears.
The status area shows lists for the copy/swap source on the left, and the
copy/swap destination on the right.
2
In the <Data Select> group, select either of the following.
Wipe: The operation applies to wipes in the transition control block.
Key Wipe: The operation applies to wipes in the independent key
transition control block.
To Next Page
Loading...
