Chapter 17 Files
786
Operations on Individual Files
Copying Files
You can copy files either within a directory or between directories, on the hard
disk, or memory card.
As an example, to copy a snapshot file from memory card to hard disk, use the
following procedure.
1
In the File menu, select VF3 ‘Snapshot’ and HF1 ‘Snapshot.’
2
In the device selection area on the left, specify the location of the file to be
copied (in this case [Memory Card] and a directory). (See page 782.)
3
In the device selection area on the right, select the destination of the copied
file (in this case [HDD] and a directory).
4
Using any of the following methods, select the source and destination files.
• To select all files within the list, press [ALL] below the list.
• To select multiple files, turn the knobs to select in the following ranges.
• To select a single file, press the arrow keys to scroll the reverse video
cursor, or press directly on the list in the status area.
5
Press [t Copy].
This copies the selected file or files to the specified destination.
If there is already data in the specified location, a confirmation message
appears.
• Select “Yes” to overwrite the data.
• Select “No” to cancel copying all of the files.
Copying frame memory files
Between steps 3 and 4 of the procedure above, “Copying Files,” do as follows.
1
To select the frame memory folder, press [Default] in the device selection
in the list on the left.
A pull-down menu appears.
2
Press the required folder name.
Knob Parameter Adjustment Setting values
1 List L Select the first copy source file 1 to 99
2 List R Select the first destination file 1 to 99
3 Num Number to be selected 1 to 99
To Next Page