227Wipe Settings for Independent Key Transitions
Chapter 5 Wipes
The Pattern Select menu appears.
2
Press the button for the desired pattern.
Setting Independent Key Transition Wipe Modifiers
Available modifiers
You can use the following modifiers with an independent key transition wipe.
Note that the available modifiers may depend on the pattern you are using.
• Direction
• Edge
• Positioner
• Rotation
• Aspect ratio
• Pattern replication
Setting the wipe direction (Direction)
In the <Direction> group of the Key1 Wipe Adjust menu, make any of the
following selections.
Normal: regular direction
Normal/Reverse: alternate between regular and reverse for each transition
Reverse: reverse direction to normal
Softening the wipe pattern edge (Soft edge)
1
Press [Soft] in the Key1 Wipe Adjust menu, turning it on.
2
Set the following parameter.
Setting the wipe position (Positioner)
There are two methods of setting the wipe position: using the device control
block, or in a menu.
To set the wipe position using the trackball
You can also set the wipe position using the trackball in the device control
block.
Knob Parameter Adjustment Setting values
1 Soft Edge softness 0.00 to 100.00
To Next Page
Loading...
