Sony DVS-9000 System - Specifying Main Split Fader; Setting the Macro Execution Mode

Chapter 19 Control Panel Setup (Panel)
934
Operation Settings (Operation Menu)
2 Make the following settings as required.
Trackball and Z-ring sensitivity in normal mode: In the <Trackball
Normal Mode> group, select [× 1], [× 2], or [× 4].
Trackball and Z-ring sensitivity in fine mode: In the <Trackball Fine
Mode> group, select [
1
/
2
], [
1
/
4
], or [
1
/
8
].
Joystick sensitivity in normal mode: In the <Joystick Normal Mode>
group, select [× 1], [× 2], or [× 4].
Joystick sensitivity in fine mode: In the <Joystick Fine Mode> group,
select [
1
/
2
], [
1
/
4
], or [
1
/
8
].
Touch sensitivity for recalling menus by double-clicking buttons: In
the <Double Click> group, select [Fast], [Normal], or [Slow].
Search dial rotation angle to attain the same playback speed: In the
<SHTL/VAR Dial Range> group, select [Narrow] or [Wide].
Specifying Main Split Fader
In the <Main Split Fader> group of the Panel >Operation menu, select [Left]
or [Right].
Note
This setting is disabled for the CCP-9000/9000A.
Setting the Macro Execution Mode
1 Press [Macro] in the Panel >Operation menu.
The Macro menu appears.
2 In the <Macro Execution Mode> group, select the macro execution mode.
Normal: normal execution mode
Step: step execution mode
3 In the <Flexi Pad Edit Mode> group, set the macro editing mode of the
standard type Flexi Pad to [Pause Only] or [Full Editing].
This enables the standard type Flexi Pad control block to be used for macro
editing. Depending on the macro editing mode setting, functions are
assigned to the memory recall buttons as shown in the following figure.