845Selecting the State After Powering On (Start Up Menu)
Chapter 18 System Setup (System)
5
Select [Yes].
The start-up state settings are saved.
Saving User-Defined Settings
Saving the Setup settings
1
After selecting the devices to which the settings apply to, in the System
>Start Up menu, press [Setup Define].
A confirmation message appears.
2
Press [Yes].
This saves the setup settings for the selected devices in non-volatile
memory within the respective devices.
For details about the settings which will be saved, see“Data Saved by
[Setup Define] and [Initial Status Define]” (page 1040).
Saving the Initial Status settings
1
After selecting the devices to which the settings apply to, in the System
>Start Up menu, press [Init Status Define].
A confirmation message appears.
2
Press [Yes].
This saves the initial status settings other than the “setup” settings for the
selected devices in non-volatile memory within the respective devices.
For details about the settings which will be saved, see “Data Saved by
[Setup Define] and [Initial Status Define]” (page 1040).
Setting Automatic Loading of Register Data at Power
On (Autoload Function)
To have specified data read in at power on, in the System >Start Up menu,
press [Power On File Load], turning it on.
This enables the autoload function.
To Next Page
Loading...
