763Menu Macros
Chapter 16 Macros
Executing a menu macro
In the Macro >Menu Macro Register >Recall & Run menu, check that you are
not in macro editing mode, then use the following procedure.
1
Using any of the following methods, specify the event from which you
want to execute.
• Press directly on the menu macro register configuration list.
• Press the arrow keys on the right list to scroll the reverse video cursor.
• Turn the knob.
2
Press [Run].
This executes the menu macro from the specified event.
To stop execution of a macro
Press [Stop].
To move to the start of a menu macro event
Press [Rewind].
Recalling a menu macro register from a macro register
Menu macro recall and execution operations can be saved as events in a control
panel macro, and then recalled.
If with the control panel in macro editing mode you execute a menu macro,
then this operation is recorded as an event.
For details of recording operations, use the following references, depending
on the control panel or menu used.
• Using the numeric keypad control block and the keyframe control block:
page 730
• Using menus: page 745
Menu Macro Creation and Editing
Create or edit menu macro registers.
Note
It is not possible to execute a menu macro during editing. To run the macro,
first press the [Store] button to end editing.
Knob Parameter Adjustment Setting values
3 No Select start event 1 and upwards
To Next Page