232
Wipe Snapshots
Chapter 5 Wipes
Saving a wipe snapshot from the menu
1
Set up the wipe you want to save.
2
In the Wipe Snapshot menu, press [Store], lighting it amber.
3
Press the memory recall button for the register in which you want to save.
Notes
• If you press a button which is already lit, this overwrites the contents of
the register.
• When both the main pattern and sub pattern are selected for a pattern
mix, the button in the memory recall section shows only the main
pattern.
Recalling a wipe snapshot from the menu
In the Wipe Snapshot menu, press the memory recall button for the wipe
snapshot you want to recall.
This recalls the wipe snapshot, and the button you pressed lights amber.
In the upper left is shown the currently recalled register name or number.
Note
The Flexi Pad and menu settings are linked.
A setting in setup determines whether register names or pattern numbers
appear.
Deleting a wipe snapshot from the menu
1
In the Wipe Snapshot menu, press [Delete].
2
Press the memory recall button for the wipe snapshot you want to delete.
This deletes the wipe snapshot.
To Next Page