Chapter 9 Color Corrector
352
Color Corrector Functions
Note
When secondary color correction is enabled in the setup settings, this function
is disabled.
For details, see “Switching the Color Correction Function” in Chapter 18
(Volume 3).
Adjusting the color of the specified region (key)
1
In the CCR menu, press VF1 ‘CCR1’ and HF6 ‘Spot CCR/Output.’
The Spot CCR/Output menu appears.
2
In the <Spot CCR> group, press [Spot CCR], turning it on.
3
In the <Auto> group, press [Sample Mark], turning it on.
Note
When [Sample Mark] is on, the effects of color adjustment outside the
region of spot color adjustment (see page 353) and output video processing
(see page 354) are temporarily disabled.
Turning [Sample Mark] off restores the former state.
4
Adjust the parameters so that the color you want to change is included
within the sample mark.
5
In the <Auto> group, press [Auto Start], to adjust the key automatically.
Note
This automatic adjustment does not carry out key gain adjustment. If
required, adjust the key gain as shown in step 6.
6
Press [Key Adjust], and adjust the following parameters.
Knob Parameter Adjustment Setting values
1 Position H Horizontal position –100.00 to +100.00
2 Position V Vertical position –100.00 to +100.00
3 Size Size 1.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance –7.31 to +109.59
2 Saturation Saturation 0.00 to 100.00
To Next Page