Chapter 11 DME Operations
532
DME Special Effect Operations
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not
decay.
4
In the <Decay Mix Mode> group, select the way in which the video signal
is blurred.
Soft: mix the live image and the afterimage.
Hard: show the lighter of the live image and afterimage.
5
To erase the afterimage, press [Decay Eraser], turning it on.
Erasing the afterimages that remain in memory whenever a
keyframe is passed
Press [Decay Eraser], turning it on.
When the effect passes a keyframe, the afterimage is erased before writing a
new afterimage.
Selecting the freeze timing
In the <Decay Freeze Timing> group, select the timing for motion decay
freezing.
Frame: freeze in frame units.
Field: freeze in field units.
Applying stardust to the afterimage portion
The afterimage portion becomes stardust, and gradually disappears.
1
Press the [DUST] button, turning it on.
2
Set the following parameters.
a) The way in which the afterimage disappears is affected by both the Video Decay and
Decay Dust parameter adjustments for the motion decay.
Knob Parameter Adjustment Setting values
1 Decay Dust Amount of the afterimage
disappearing as stardust
a)
0.00 to 100.00
2 Dust Soft Timing with which stardust
disappears
0.00 to 100.00
3 Dust Size Size of stardust 0.00 to 100.00
4 Dust Aspect Aspect ratio of stardust –100.00 to +100.00
To Next Page
Loading...
