Sony DVS-9000 System - Page 703

703Snapshot Operations in the Menus
Chapter 14 Snapshots
5 Press the button for the number or name you want to save.
This saves the snapshot, and the button goes off.
Changing the bank
Change the combination shown on the memory recall buttons (the bank).
1 Press [Bank Sel].
2 Select the bank in the numeric keypad window.
For example, to show the numbers or names corresponding to registers 11
to 20, select “1” in the numeric keypad window.
Applying attributes
To apply an attribute to the snapshot represented by a lit-green memory recall
button, use the following procedure.
1 To apply the cross-point hold attribute, in the <Attribute Xpt Hold> group
select the appropriate bus.
Note
A setting in the Setup menu determines whether key disable is applied to
cross-point hold or not. For details, see “Setting the Operation Mode of the
Key Bus [XPT HOLD] Button” in Chpater 20 (Volume 3).
2 Select the following attributes in the <Attribute> group as required.
Effect Dissolve: Apply effect dissolve.
Auto Transition: Apply auto transition.
GPI Output: Apply GPI output. When this is selected, select the GPI
number with the knob.
Deleting a snapshot
1 In the Misc >Snapshot menu, press [Delete].
The button lights amber.
2 As required, change the bank.
3 Press the button for the number or name you want to delete.
This deletes the snapshot, and the button you pressed goes off.