734
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Chapter 16 Macros
• To move to an edit point by specifying an event number (the number
showing the position of the event in the macro execution sequence),
press the [GO TO KF] button in the keyframe control block, then in the
numeric keypad control block, enter the target number and confirm with
the [ENTER] button.
Inserting an event
1
Specify the edit point. (See page 733.)
2
If required, press the [AUTO INS] button assigned to a utility/shotbox
control block or user preference button, to toggle the auto insert mode on
or off.
3
Create the event.
• When auto insert mode (see page 731) is on, the event is automatically
added to the macro.
• When auto insert mode is off, proceed to step 4.
4
When auto insert mode is off, press the [INS] button in the keyframe
control block.
5
Repeat steps 2 and 3 to insert the required events in the macro.
Modifying a single event
1
Specify the edit point. (See page 733.)
2
When the [AUTO INS] button assigned to a utility/shotbox control block
button or user preference button is lit, press this to turn the auto insert mode
off.
3
Create the event.
4
Press the [MOD] button in the keyframe control block.
Modifying a particular range of events
1
Carry out steps 1 to 3 of the procedure in “Modifying a single event” (the
previous item).
2
Press the [FROM TO] button in the keyframe control block, turning it on.
To Next Page