738
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Chapter 16 Macros
1
In the numeric keypad control block, press the [MCRO] button, turning it
on.
This assigns the numeric keypad control block to macro operations.
2
Press the [STORE] button, turning it on.
3
Enter the number of the register in which you want to save the macro with
the numeric keypad buttons.
To search for an empty register, instead of entering a number, press the [.]
(period) button.
The display shows the corresponding register number. A letter “E” after
the number indicates that the corresponding register is empty.
4
Press the [ENTER] button.
This saves the macro data in the specified register, and the [STORE] button
goes off.
The [RCALL] and [STORE STATS] buttons light.
To cancel the saving of a macro
To cancel the saving of a macro immediately after performing it, hold down the
[STORE STATS] button and press the [UNDO] button.
To Next Page