ST STM32F2 - Page 156

HAL CRYP Generic Driver
UM1940
156/1371
DocID028236 Rev 2
__HAL_CRYP_RESET_HANDLE_STATE
Description:
Reset CRYP handle state.
Parameters:
__HANDLE__: specifies the CRYP
handle.
Return value:
None
__HAL_CRYP_ENABLE
Description:
Enable/Disable the CRYP peripheral.
Parameters:
__HANDLE__: specifies the CRYP
handle.
Return value:
None
__HAL_CRYP_DISABLE
__HAL_CRYP_FIFO_FLUSH
Description:
Flush the data FIFO.
Parameters:
__HANDLE__: specifies the CRYP
handle.
Return value:
None
__HAL_CRYP_SET_MODE
Description:
Set the algorithm mode: AES-ECB, AES-
CBC, AES-CTR, DES-ECB, DES-CBC.
Parameters:
__HANDLE__: specifies the CRYP
handle.
MODE: The algorithm mode.
Return value:
None
__HAL_CRYP_GET_FLAG
Description:
Check whether the specified CRYP flag is
set or not.
Parameters:
__HANDLE__: specifies the CRYP
handle.
__FLAG__: specifies the flag to check.
This parameter can be one of the
following values: