ST STM32F2

UM1940
HAL TIM Generic Driver
DocID028236 Rev 2
579/1371
Time Base : HAL_TIM_Base_Start(), HAL_TIM_Base_Start_DMA(),
HAL_TIM_Base_Start_IT()
Input Capture : HAL_TIM_IC_Start(), HAL_TIM_IC_Start_DMA(),
HAL_TIM_IC_Start_IT()
Output Compare : HAL_TIM_OC_Start(), HAL_TIM_OC_Start_DMA(),
HAL_TIM_OC_Start_IT()
PWM generation : HAL_TIM_PWM_Start(), HAL_TIM_PWM_Start_DMA(),
HAL_TIM_PWM_Start_IT()
One-pulse mode output : HAL_TIM_OnePulse_Start(),
HAL_TIM_OnePulse_Start_IT()
Encoder mode output : HAL_TIM_Encoder_Start(),
HAL_TIM_Encoder_Start_DMA(), HAL_TIM_Encoder_Start_IT().
6. The DMA Burst is managed with the two following functions:
HAL_TIM_DMABurst_WriteStart() HAL_TIM_DMABurst_ReadStart()
45.2.3 Time Base functions
This section provides functions allowing to:
Initialize and configure the TIM base.
De-initialize the TIM base.
Start the Time Base.
Stop the Time Base.
Start the Time Base and enable interrupt.
Stop the Time Base and disable interrupt.
Start the Time Base and enable DMA transfer.
Stop the Time Base and disable DMA transfer.
This section contains the following APIs:
HAL_TIM_Base_Init()
HAL_TIM_Base_DeInit()
HAL_TIM_Base_MspInit()
HAL_TIM_Base_MspDeInit()
HAL_TIM_Base_Start()
HAL_TIM_Base_Stop()
HAL_TIM_Base_Start_IT()
HAL_TIM_Base_Stop_IT()
HAL_TIM_Base_Start_DMA()
HAL_TIM_Base_Stop_DMA()
45.2.4 Time Output Compare functions
This section provides functions allowing to:
Initialize and configure the TIM Output Compare.
De-initialize the TIM Output Compare.
Start the Time Output Compare.
Stop the Time Output Compare.
Start the Time Output Compare and enable interrupt.
Stop the Time Output Compare and disable interrupt.
Start the Time Output Compare and enable DMA transfer.
Stop the Time Output Compare and disable DMA transfer.
This section contains the following APIs:
HAL_TIM_OC_Init()