ST STM32F2

HAL PCD Generic Driver
UM1940
394/1371
DocID028236 Rev 2
a. hpcd.pData = pdev;
6. Enable PCD transmission and reception:
a. HAL_PCD_Start();
32.2.2 Initialization and de-initialization functions
This section provides functions allowing to:
This section contains the following APIs:
HAL_PCD_Init()
HAL_PCD_DeInit()
HAL_PCD_MspInit()
HAL_PCD_MspDeInit()
32.2.3 IO operation functions
This subsection provides a set of functions allowing to manage the PCD data transfers.
This section contains the following APIs:
HAL_PCD_Start()
HAL_PCD_Stop()
HAL_PCD_IRQHandler()
HAL_PCD_DataOutStageCallback()
HAL_PCD_DataInStageCallback()
HAL_PCD_SetupStageCallback()
HAL_PCD_SOFCallback()
HAL_PCD_ResetCallback()
HAL_PCD_SuspendCallback()
HAL_PCD_ResumeCallback()
HAL_PCD_ISOOUTIncompleteCallback()
HAL_PCD_ISOINIncompleteCallback()
HAL_PCD_ConnectCallback()
HAL_PCD_DisconnectCallback()
32.2.4 Peripheral Control functions
This subsection provides a set of functions allowing to control the PCD data transfers.
This section contains the following APIs:
HAL_PCD_DevConnect()
HAL_PCD_DevDisconnect()
HAL_PCD_SetAddress()
HAL_PCD_EP_Open()
HAL_PCD_EP_Close()
HAL_PCD_EP_Receive()
HAL_PCD_EP_GetRxCount()
HAL_PCD_EP_Transmit()
HAL_PCD_EP_SetStall()
HAL_PCD_EP_ClrStall()
HAL_PCD_EP_Flush()
HAL_PCD_ActivateRemoteWakeup()
HAL_PCD_DeActivateRemoteWakeup()