HAL_TIMEx_PWMN_Start_DMA
HAL_StatusTypeDef HAL_TIMEx_PWMN_Start_DMA
(TIM_HandleTypeDef * htim, uint32_t Channel, uint32_t *
pData, uint16_t Length)
Starts the TIM PWM signal generation in DMA mode on the
complementary output.
htim: pointer to a TIM_HandleTypeDef structure that
contains the configuration information for TIM module.
Channel: TIM Channel to be enabled. This parameter can be
one of the following values:
TIM_CHANNEL_1: TIM Channel 1 selected
TIM_CHANNEL_2: TIM Channel 2 selected
TIM_CHANNEL_3: TIM Channel 3 selected
TIM_CHANNEL_4: TIM Channel 4 selected
pData: The source Buffer address.
Length: The length of data to be transferred from memory to
TIM peripheral
HAL_TIMEx_PWMN_Stop_DMA
HAL_StatusTypeDef HAL_TIMEx_PWMN_Stop_DMA
(TIM_HandleTypeDef * htim, uint32_t Channel)
Stops the TIM PWM signal generation in DMA mode on the
complementary output.
htim: pointer to a TIM_HandleTypeDef structure that
contains the configuration information for TIM module.
Channel: TIM Channel to be disabled. This parameter can
be one of the following values:
TIM_CHANNEL_1: TIM Channel 1 selected
TIM_CHANNEL_2: TIM Channel 2 selected
TIM_CHANNEL_3: TIM Channel 3 selected
TIM_CHANNEL_4: TIM Channel 4 selected
HAL_TIMEx_OnePulseN_Start
HAL_StatusTypeDef HAL_TIMEx_OnePulseN_Start
(TIM_HandleTypeDef * htim, uint32_t OutputChannel)
Starts the TIM One Pulse signal generation on the complementary
output.
htim: pointer to a TIM_HandleTypeDef structure that
contains the configuration information for TIM module.
OutputChannel: TIM Channel to be enabled. This parameter
can be one of the following values:
TIM_CHANNEL_1: TIM Channel 1 selected
TIM_CHANNEL_2: TIM Channel 2 selected