ST STM32F2 User Manual

UM1940
HAL RCC Generic Driver
DocID028236 Rev 2
441/1371
Parameters:
__INTERRUPT__: specifies the RCC
interrupt sources to be enabled. This
parameter can be any combination of the
following values:
RCC_IT_LSIRDY: LSI ready interrupt.
RCC_IT_LSERDY: LSE ready interrupt.
RCC_IT_HSIRDY: HSI ready interrupt.
RCC_IT_HSERDY: HSE ready
interrupt.
RCC_IT_PLLRDY: Main PLL ready
interrupt.
RCC_IT_PLLI2SRDY: PLLI2S ready
interrupt.
__HAL_RCC_DISABLE_IT
Description:
Disable RCC interrupt (Perform Byte access
to RCC_CIR[14:8] bits to disable the
selected interrupts).
Parameters:
__INTERRUPT__: specifies the RCC
interrupt sources to be disabled. This
parameter can be any combination of the
following values:
RCC_IT_LSIRDY: LSI ready interrupt.
RCC_IT_LSERDY: LSE ready interrupt.
RCC_IT_HSIRDY: HSI ready interrupt.
RCC_IT_HSERDY: HSE ready
interrupt.
RCC_IT_PLLRDY: Main PLL ready
interrupt.
RCC_IT_PLLI2SRDY: PLLI2S ready
interrupt.
__HAL_RCC_CLEAR_IT
Description:
Clear the RCC's interrupt pending bits
(Perform Byte access to RCC_CIR[23:16]
bits to clear the selected interrupt pending
bits.
Parameters:
__INTERRUPT__: specifies the interrupt
pending bit to clear. This parameter can be
any combination of the following values:
RCC_IT_LSIRDY: LSI ready interrupt.
RCC_IT_LSERDY: LSE ready interrupt.
RCC_IT_HSIRDY: HSI ready interrupt.
RCC_IT_HSERDY: HSE ready
interrupt.
RCC_IT_PLLRDY: Main PLL ready
interrupt.
RCC_IT_PLLI2SRDY: PLLI2S ready

ST STM32F2 Specifications

General

Brand	ST
Model	STM32F2
Category	Microcontrollers
Language	English